Please use this identifier to cite or link to this item: http://repository.uma.ac.id/handle/123456789/15290
Title: Applied Computational Fluid Dynamics in Electronics Packaging
Other Titles: Dinamika Fluida Komputasi Terapan dalam Kemasan Elektronik
Authors: Ramdan, Dadan
Keywords: fluid dynamics
applied computational
electronics packaging
Issue Date: Apr-2015
Publisher: Medan Area University Press
Abstract: This is an introductory textbook for Applied Computational Fluid Dynamics in Electronics Packaging. The reduction of IC chip size has a significant impact to the modern electronic industry especially on the circuit design and IC assembly process. The increasing of I/O counts in a small scale IC chip result in severe wire deformation and deformation issues during transfer moulding process. In this book, visualization of wire sweep phenomenon during the encapsulation process of plastic ball grid array (PBGA) package is studied through a three-dimensional (3D) fluid structure interaction (FSI) technique; which FV- and FE-based software are connected by using mesh-based parallel code coupling interface (MpCCI). The effect of polymer rheology, inlet pressure, arrangement of inlet gate, number of stacked die, wire diameter and size of mould cavity vents, on the melt flow behaviour, wire sweep, filling time, cavity pressure and stress distributions, are mainly studied. A 3D model of mould and wires was created by using GAMBIT, and the fluid/structure interaction was simulated by using FLUENT and ABAQUS software integrated with MpCCI for the real-time calculations. The Castro-Macosko model and Kamal model are used to incorporate the polymer rheology and the Volume of Fluid (VOF) technique is applied for melt front tracking. User-defined functions (UDFs) were incorporated to allow the curing kinetics. However, in the experimental work, the effects of FSI phenomenon in the PBGA package was studied using a scaled-up package size to mimic the encapsulation process. The effects of stacked die, inlet gate arrangement, outlet vent, and inlet pressure of mould cavity on the melt flow behaviour and wire sweep were investigated. The constant viscosity of test fluid was utilized for experiment. The numerical results of melt front patterns and wire sweep were compared with the experimental results and it was found in good conformity. Three types of Epoxy Moulding Compound (EMC) were utilized for the study of fluid flow within the mould cavity. The melt front profiles and viscosity versus shear rate for all cases were analyzed and presented. The numerical results of melt front behaviour and wire sweep were compared with the previous experimental results and found in good agreement. In the present study, the lower viscosity shows the lower air trap, lower pressure distributions and lower wire deformation. Optimized design of the PBGA gives better PBGA encapsulation process and minimizes the wire sweep. The physical and process parameter (i.e., pressure inlet, wire diameter, vent height) were optimized via response surface methodology (RSM) using central composite design (CCD) to minimize the deformation of wire sweep, filling time and void in package during the PBGA encapsulation process. Fluid structure interaction (FSI) was considered in the optimization of the PBGA encapsulation process. The optimum empirical models were tested and well confirmed with the simulation results. The optimum design of the PBGA with 12 wires for both physical and process parameters ware characterized by 5.57 MPa inlet pressure, 0.05 mm wire diameter, and 0.36 mm vent height. Therefore, the strength of MpCCI code coupling in handling FSI problems is proven to be excellent. This present work is expected to be a reference and guideline for microelectronics industry.
Description: 162 Halaman;20 Cm
URI: http://repository.uma.ac.id/handle/123456789/15290
ISBN: 978-602-1577-11-0
Appears in Collections:Books



Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.